Publicité
Les langues disponibles
Les langues disponibles
Front Facing Installation
H
H
NOTE: All dimensions in the Side Facing and the Front
Facing illustrations apply for any grill installation.
Min. 61/2" (165.1mm) thickness of the drawer for grill
A
install
B
The depth of cut out size: 13" (330.2mm)
C
The width of cut out size: 19" (482.6mm)
Min. 2" (50.8mm) from the drawer counter surface to
D
the top of the drawer opening
Min. 2" (50.8mm) distance to the front and rear sides
E
of the cut out to support the grill
Min. 30" (1016mm) distance from drawer counter top
F
surface to the overhang material above. Temperature
requirement minimum is 149
Min. 31/2" (88.9mm) distance to the left and right
G
sides of the cut out to support the grill
Min. 3" (76.2mm) clearance around the grill to the
H
combustible material above the counter top surface
Min. 12" (305mm) clearance from bottom of the grill
I
to any combustible material below the drawer (if you
install something below the drawer)
Min. 2" (50.8mm) distance from the front and rear
J
heat shield surfaces to the combustible material on
the inner front and rear surfaces of the drawer
Min. 5" (127.0mm) distance from the left side heat
K
shield surface to the combustible material on the
inner left side surface of the drawer
Min. 61/2" (165.1mm) distance from the right side heat
L
shield surface to the combustible material on the
inner right side surface of the drawer
WARNING
For outdoor use only.
You grill is designed to be installed into an exterior counter
top and a pull-out drawer that extends away from the RV. It is
not designed to be installed in an enclosed cabinet.
When in use, the bottom of the grill must be free and clear
5
All manuals and user guides at all-guides.com
H
J
I
L
F (65
C)
o
o
from all combustibles.
The grill must only be installed in a pull-out drawer.
Combustible wall and overhead clearances must be
maintained.
A safety shut off valve must be installed for easy accessibility
to turn off the gas to the grill.
After the installation is completed, the grill and gas
connection must be checked for any leaks.
H
Install the Grill
1. Lift up the front of the lid (a), hold both sides of the lid and
push it a little to make the lid hinges separate from the grill
base (b), then take the lid off (only for model FGL202A-SS).
2. Place the grill into the cutout at a 30 degree angle as
shown in illustration Fig. A, Fig. B, and Fig. C.
a. Place the grill knob side into the cabinet (Fig. A).
Fig. A
b. Push down on the left side to seat the grill into the
cutout (Fig. B).
Fig. B
c. Pull back the grill to the left until the limit bracket hits
the cabinet cutout (Fig. C).
WARNING
b
a
Publicité
