anti-tiPPing DEvicE
1. Attach one of the mounting brackets (i) securely to the back edge
of the furniture. Use the small screws (k).
2. Determine where furniture is to be placed and mark location on
the wall for the other mounting bracket (i) screw holes. You may
need to use 2 anchors (h) if you are attaching to drywall or plaster.
3. position the bracket over the holes and use the large screws (j) to
securely attach the bracket to wall.
4. place the furniture so the mounting bracket (i) on the back edge is
in line with the mounting bracket (i) on the wall.
5. place an end of the nylon restraint strap (l) down through each
bracket (i). bring both ends together and slide the end of the
nylon strap (l) through the slot in the other end until snug. pull
down on the end until it snap locks into the slot.
6. Check to make sure the strap (l) is securely laced and locked to
the mounting brackets (i).
Young children may be injured by tipping furniture. The use of a
tipping restraint is highly recommended. This hardware, when
properly installed, could provide protection against the unexpected
tipping of furniture due to improper use.
Warning: This product is only a deterrent. It is not a substitute for
proper adult supervision.
One anti-tip device includes the following:
j
h
i
FIT UP TO 60" PLASMA/LCD/LED TELEVISIONS
MAXIMUM LOAD 75 lb. (34 kg)
MAXIMUM LOAD
30 lb. (13.6kg)
caUtiOn: This unit is intended for use only with the products and
maximum weights indicated. Use with other products or products
heavier than the maximum weights indicated may result in instability
causing possible injury.
note: Flat panel TVs with base support should be placed squarely
in the center of the stand with no overhang on any side.
(instructions included with hardware)
k
l
Hardware Used
h
Anchor
i
Mounting bracket
j
Large Screw
k
Small Screw
MANTEL
MANTEL
WALL
Hardware Used
l
Nylon Strap
WALL
x 2
x 2
x 2
x 2
WALL
x 1