Zyxel DMA-1000W Guide Rapide page 10

3 Use this step if you want to use a wired connection instead
of a wired connection (the DMA-1000W only supports one
type at a time). Refer to the User's Guide to configure
wired LAN settings. Skip to the next step if you will use a
wireless connection. Connect the DMA-1000W's LAN port
if your content files are on your computer. The media
server software should already be installed. Skip to the
next step if you will only play files from a USB stick.
• Use the straight-through Ethernet cable (gray at the
time of writing) to connect to an Ethernet switch, router
or hub.
• Use the cross-over Ethernet cable (red at the time of
writing) to connect directly to your computer.
4 If you want to play files from a USB memory stick, connect
it to the DMA-1000W's USB port. This is optional if you use the wired or wireless
connection to connect to your computer.
5 Connect the POWER socket to a power source
using only the included power adaptor.
6 Point the antenna towards the ceiling. You will
also need to configure the wireless settings to
have the DMA-1000W connect to your computer
or wireless Access Point (AP). See section
7 Your computer should already be turned on. Turn
on the TV and the DMA-1000W.
2.1 Check the LEDs (Lights)
Look at the front of the device.
1 The STATUS LED comes on.
2 The LAN light and/or the USB light turn on.
Check your connections if the lights do not come on.
ENGLISH
3 .
10