Publicité
Les langues disponibles
Les langues disponibles
BM 2610006360 03-09:BM 2610006360 03-09 3/18/09 1:42 PM Page 11
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting
the tool accidentally.
When working, never hold tool with your
hand or fingers in area of the saw blade. The
fingers of the guiding hand must always be
kept behind the limiting ridge (Fig. 14).
FIG. 14
LIMITING
RIDGE
SLIDE "ON/OFF" SWITCH
The tool is switched "ON" by the slide switch
located on the topside of the motor housing.
TO TURN THE TOOL "ON", slide the switch
button forward.
TO TURN THE TOOL "OFF", slide the switch
button backward.
VARIABLE SPEED DIAL
Your tool is equipped with a variable speed
dial. The blade stroke rate may be adjusted
during cutting operation by setting the dial on
or between any one of the six numbers.
The optimum stroke rate depends on the
material and must be determined by testing
on similar materials in each application.
All manuals and user guides at all-guides.com
Operating Instructions for Saw
direction of the body (Fig. 15).
FIG. 15
The cutting action of this saw is similar to a
handsaw.
Place the blade on the edge of the work-
piece. The blade should be held at a steep
angle to the workpiece approx. 60° (Fig. 16A.)
It is difficult to begin cutting on the flat of a
workpiece (Fig.16B).
FIG. 16
Pull blade thru the workpiece maintaining a
steep angle when cutting (Fig. 17A).
Do not start cutting on the back edge and
allow tip to plunge into workpiece (Fig. 17B)
FIG. 17
-11-
POSITIONING THE BLADE
AGAINST THE WORK
Never saw with the blade
W RNING
facing upward or in the
60°
A
A
B
B
Publicité
