Swagelok M200 Instructions D'utilisation page 3

M200 Calibration Unit
User Instructions
The M200 calibration unit is used to calibrate the current and voltage of the Swagelok
the rotor speed of Swagelok weld heads This enables you to ensure the equipment is operating within specification
without removing it from service
Included with Calibration Unit
Welding cables
SWS-M200-CAL-WELD-CABLE
Digital multimeter
(representative image)
SWS-M200-CAL-METER
M100 Users Only
The current output of the M100 power supply can be verified with an optional cable (SWS-M100-CAL-PWR-ADPTR)
The M200 calibration unit will not perform a calibration of the M100 power supply Contact your authorized Swagelok
representative for additional information
All manuals and user guides at all-guides.com
SWS-M200-CAL
Wire harness (Input/Output)
SWS-M200-CAL-SENS-WR
® M200 power supply and verify
Dual Banana Jacks
SWS-M200-CAL-VOLT-PLUG
3