Playing A Usb Flash Drive; Reproducir Una Unidad Usb; Clock And Timer; Horloge Et Minuterie - Onkyo CS-355 Manuel D'instructions

Playing a USB Flash
Drive
This section describes the procedure for using the
remote controller, unless otherwise specified.
1 Press the [iPod] button to select "iPod".
Alternatively, you can use the CD receiver's
[INPUT] button.
2 Press and hold the [MODE] button until
"USB" appears (about 3 seconds).
3 Insert a USB flash drive in the USB port.
USB flash drive
4 To start playback, press the [1/3] button.
Selecting folders and files, and using the random
play and repeat play functions, are the same as
when playing back MP3 files from a CD (see
page 20).
Note:
• Do not connect your USB flash drive via a USB hub.
• When connecting or disconnecting a USB flash drive,
use your hand to support the CD receiver so that it
does not move.
• For details on the usable formats for a USB flash
drive, refer to page 12 "Playback from USB Flash
Drives".
• If your iPod/iPhone/iPad is used, switch the
connection mode to iPod (see page 22).
• Do not connect the CD receiver's USB port to a USB
port on your computer. Music on your computer
cannot be played through the CD receiver in this way.
26
En-

Setting the Clock

This section describes the procedure for using the
remote controller, unless otherwise specified.
Setting the Clock
1 Press the [TIMER] button repeatedly until
"Clock" appears.
2 Press [ENTER].
3 Use the arrow [q]/[w] buttons to enter the
current hour.
When the CD receiver is shipped from the factory,
the time display format is set to 24-hour time. Set
the current hour as it would appear in 24-hour time.
If you want to set the current hour as 12-hour time,
press the [DISPLAY] button.
4 Press [ENTER].
5 Use the arrow [q]/[w] buttons to enter the
current minute.
6 Press [ENTER].
The clock is set and the second dot starts flashing.
Displaying the Time
To display the time, press the remote controller's
[CLOCK CALL] button. Press the button again or
perform another operation to cancel the time display.
If the CD receiver is on Standby, the time will be
displayed for about 8 seconds.
While the CD receiver is on, the time are displayed
continuously.
Change the time format
To change the time format between 12-hour and 24-hour,
press the [DISPLAY] button.