Fan Power Connectors: CPU_FAN1/ SYS_FAN1
The 4-pin CPU_FAN1 (processor fan) and 3-pin SYS_FAN1 (system fan)
support system cooling fan with +12V. CPUFAN1 can support three- or four-pin
head connector. When connecting the wire to the connectors, always take note
that the red wire is the positive and should be connected to the +12V, the black
wire is Ground and should be connected to GND. If the mainboard has a
System Hardware Monitor chipset on-board, you must use a specially
designed fan with speed sensor to take advantage of the CPU fan control.
MSI Reminds You...
Always consult the vendors for the proper CPU cooling fan.
Front Panel Connectors: JFP1
The mainboard provides two front panel connectors for electrical connection to
the front panel switches and LEDs. JFP1 is compliant with Intel
Connectivity Design Guide.
Front Panel Audio Connector: JAUDIO1
The front panel audio connector allows you to
connect to the front panel audio and is compliant with
®
Intel
Front Panel I/O Connectivity Design Guide.
MSI Reminds You...
If you do not want to connect to the front audio header, pins 5 & 6, 9 & 10 have to
be jumpered in order to have signal output directed to the rear audio ports.
Otherwise, the Line-Out connector on the back panel will not function.
Front USB Connector: JUSB1/ JUSB2
The mainboard provides two standard USB 2.0 pin headers
JUSB1&JUSB2. USB2.0 technology increases data transfer
rate up to a maximum throughput of 480Mbps, which is 40
times faster than USB 1.1, and is ideal for connecting
high-speed USB interface peripherals such as USB HDD,
digital cameras, MP3 players, printers, modems and the like.
MSI Reminds You...
Please note that the pins of VCC & GND must be connected correctly or it may cause some
damage
®
Front Panel I/O
AUD_RET_L
Key
AUD_RET_R
AUD_VCC
AUD_GND
(10)USB0C
9
Sensor
+12V
GND
Control
Sensor
+12V
GND
Reset
Switch
9
10
Power
Switch
JFP1
10
9
AUD_FPOUT_L
HP_ON
AUD_FPOUT_R
AUD_MIC_BIAS
AUD_MIC
2
1
USB0+
GND
USB0-
(9)Key
GND
USB1-
USB1+
HDD
LED
1
2
Power
LED
VCC(1)
VCC(2)