Glacier bay 305514647 Guide D'installation Et D'entretien page 8

Installation (continued)
7
Installing the batteries
NOTE: This step is for batteries installation (optional). If the
batteries will not be used, install as described in step 10.
□
To open the battery housing, squeeze the sides while pulling the cover (1). DO NOT pull on the wire.
See gure 1.
□
Install the four AA batteries (J) included by matching the positive (+) and Negative (-) ends on the battery (J)
to the (+) and (-) markings in the battery pack (I). The negative ends of the battery (J) should always
connect to the spring end of the battery slots in the battery pack (I). See gure 2.
□
Reinstall the battery pack cover (1) by pushing up and snapping into place. See gure 3.
NOTE: When the sensor ashes 10 times continuously
and slowly, the batteries have lost their charge. Replace
the batteries (J).
Figure 1
All manuals and user guides at all-guides.com
I
I
1
Figure 2
I
J
(-)
J
8
I
(+)
(-)
I
(+)
(-)
Figure 3
1