ASROCK H310CM-HDV Mode D'emploi page 22

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, 2, No. 16)
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
Chassis/Water Pump Fan
Connector
(4-pin CHA_FAN1/WP)
(see p.1, 2, No. 4)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.1, 2, No. 2)
ATX Power Connector
(24-pin ATXPWR1)
(see p.1, 2, No. 5)
20
All manuals and user guides at all-guides.com
OUT_RET OUT2_L
J_SENSE
MIC_RED
PRESENCE#
GND
1
GND
FAN_VOLTAGE
FAN_SPEED
FAN_SPEED_CONTROL
1 2 3 4
FAN_SPEED_CONTROL
CPU_FAN_SPEED
FAN_VOLTAGE
GND
1 2 3 4
12 24
1 13
This header is for
connecting audio devices
OUT2_R
to the front audio panel.
MIC2_R
MIC2_L
This motherboard
provides a 4-Pin water
cooling chassis fan
connectors. If you plan to
connect a 3-Pin chassis
water cooler fan, please
connect it to Pin 1-3.
This motherboard
provides a 4-Pin CPU fan
(Quiet Fan) connector.
If you plan to connect a
3-Pin CPU fan, please
connect it to Pin 1-3.
This motherboard
provides a 24-pin ATX
power connector. To use a
20-pin ATX power supply,
please plug it along Pin 1
and Pin 13.