marklin Ardelt 57t Mode D'emploi page 10

Safety Notes
• This model is to be used only with an operating system
designed for it (Märklin AC, Märklin Delta, Märklin Digital,
DCC or Märklin Systems).
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This model must never be supplied with power from more
than one transformer.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
• WARNING! This product contains magnets. Swallowing
more than one magnet may cause death in certain circum-
stances. If necessary, see a doctor immediately.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.
Important Notes
• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Märklin dealer for repairs or
spare parts.
• The warranty card included with this product specifies
the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
• The minimum usable radius is 437 mm / 17-1/4".
10
All manuals and user guides at all-guides.com
Functions
• Recognition of the mode of operation: automatic.
• Mfx technology for the Mobile Station / Central Station.
• Address set at the factory: MM 77 / DCC 03
• Setting the locomotive parameters (address, accelerati-
• Mode of Operation: Locomotive Engineer
• Additional explanations about the mode of operation can
• Various controllable functions.
Note:
The digital protocol with the most possibilities is the highest
order digital protocol. The sequence of digital protocols in
descending order is:
If two or more digital protocols are recognized in the track,
the decoder automatically takes on the highest value digital
protocol.For example, if mfx & MM are recognized, the mfx
digital protocol is taken on by the decoder. Individual proto-
cols can be deactivated with Parameter CV 50.
Supplemental Notes
Moderate speed must be maintained when running the
crane car on a layout. The supports must be screwed in
place completely, and the boom must lie flat on the boom
tender car. See Pages 24 / 25.
Name set at the factory: Ardelt 57t 6664
on/braking delay, maximum speed):
with the Control Unit, Mobile Station, Central Station.
be found in the supplemental instructions (included).
Priority 1: mfx
Priority 2: DCC
Priority 3: MM