LEXIBOOK Star Wars BT2000SW Mode D'emploi page 22

1. Connect the 3.5 mm cable to the Aux-in jack (13). Connect the other end of the
3.5 mm cable to an MP3 player or another audio device.
2. Press the "POWER/SOURCE" button to turn the unit on.
3. Press the "POWER/SOURCE" button on the top panel or the "Aux in" button
on the remote (4) to switch to Aux-in mode.
4. Use the controls on the connected device to begin playing audio routed
through the unit.
DC 5V 1A USB port for charging
The USB port for charging (14) can charge all devices with the same power
range (5V, 1A). Before charging, make sure the power supply is proper for your
device.
USB port for playing MP3
Power on the unit and insert a USB Flash Drive (8GB max) into the USB Port
(10), ensuring the plug is fully and properly inserted.
If the tower do not play music from the USB automatically, press "MP3" button (2)
on the remote.
SD port for playing MP3
Insert an SD or MMC memory card into the SD port (11). Make sure it is inserted
in the right way.
If the tower do not play music from the SD card automatically, press "MP3" button
on the remote.
FM radio
Playing the radio
1. Power on the unit and ensure the FM Antenna (12) has been fully extended.
2. Press "POWER/SOURCE" to adjust to "FM" mode or press "FM" button (5) on
the remote control.
3. Press
the scan the radio stations; it will automatically stop at the nearest strong signal
station.
BT2000SW_IM1225_V05.indb 22
All manuals and user guides at all-guides.com
AUX IN SETUP
OTHER FUNCTIONS
and to select the desired FM radio station or press and hold to
22
28/05/2015 17:34