Publicité
Les langues disponibles
Les langues disponibles
- Correctly use the seal of the terminal box for the electrical motor to prevent water getting in. Likewise, position and
tighten the gland inside the cable duct of the terminal box.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Where the intended use is not as indicated, additional technical adaptations and regulations may be required.
WARNINGS DURING START-UP
Before starting the machine, check the calibration of the electric protection devices on the motor and that the protection
against electrical and mechanical contacts is correctly positioned and secure.
NOTE
The pool should not be used while the pumping equipment is running.
Do not use the pump if anyone is in contact with the water.
WARNINGS DURING ASSEMBLY AND MAINTENANCE WORK
- Take into account national installation regulations when assembling and installing the pumps.
- Make sure that water is unable to enter the motor or the live electrical parts.
- Avoid contact at all times - even accidentally - with moving machine parts while the machine is running and/or before it
comes to a complete standstill.
- Wait for the machine to come to a halt before handling it.
- Before any electrical or mechanical maintenance operation, disconnect the unit from the power supply and block the start-
up devices.
- Follow the steps below before handling the machine:
1. Disconnect the machine from the mains.
2. Block all start-up devices.
3. Check that there is no voltage in the circuits, even in the auxiliary circuits and additional services.
4. Wait for the impeller to come to a complete standstill.
The list indicated must be used as a guideline and is not binding for safety purposes. There may be particular safety
regulations in specific standards.
- For regular control:
Check that the mechanical parts are tightly secured and check the condition of the screws supporting the machine.
Check that the power conductors and isolating parts are in their correct position, are secure and in a good state of repair.
Check the temperature of the machine and the electric motor. In the event of a fault, stop the machine immediately and
contact the nearest Technical Assistance Service.
Check for machine vibrations. In the event of a fault, stop the machine immediately and contact the nearest Technical
Assistance Service.
Due to the complex nature of the cases treated, the installation, user and maintenance instructions contained in this manual
do not seek to examine all possible and imaginable cases of service and maintenance. Should you require additional
instruction or have specific problems, please do not hesitate to contact the nearest Technical Assistance Service.
The electrical installation should be done by someone qualified in working with electrical equipment. This equipment is not
designed for those with physical, sensory or mental handicap or people lacking in experience, unless done under supervision
or with instructions of use from a person in charge of safety.
Do not permit children nor adults to sit or lean on the equipment. Children should be supervised to ensure that they do
not play with the equipment.
6
All manuals and user guides at all-guides.com
ASTRALPOOL -
Victoria Dual Speed
Publicité
