AEG BK 6 Mode D'emploi page 17

The manufacturer is not responsible for damages caused by:
▪
Improper use.
▪
External forces, damage to the device and/or damage to parts of the device due to
mechanical impacts or overload.
▪
any type of modifications to the device.
▪
Using the device for purposes not described in this operating manual.
▪
Subsequent damages from improper and/or incorrect use.
▪
Moisture and/or inadequate ventilation.
▪
Unauthorised opening of the device. This will void the warranty.
Fire hazard!!
▪
Verify the on-board voltage matches the input voltage specified on the device (12 V
dC) to prevent damage to the device.
▪
The coolbag is not suitable for continuous use. otherwise overheating and permanent
damage may result.
▪
do not cover the device during use, as it may be damaged from extreme heating.
▪
Immediately stop using the device if you notice smoke or an unusual odour.
Risk of electrical shock!
▪
do no expose the device to rain or wet conditions. avoid pouring or dripping water
or other liquids over it. If water penetrates electrical devices, the risk of electric shock
increases.
▪
Please verify there is no moisture on plugs and cables. Never connect the device to
the on-board power system with wet hands.
▪
always unplug the cable from the 12 V car outlet by the plug. The cable may otherwi-
se be damaged.
▪
do not use device if damaged. damage to the device or the charging cable increases
the risk of electrical shock.
▪
do not attempt to disassemble or repair the device. Immediately have the device
repaired or replaced by a speciality shop if defective.
GB
17