Macally BTTOPBAT Guide D'utilisation page 2

GB USER GUIDE
Thank you for purchasing the Macally BTTOPBAT.
The Macally BTTOPBAT is a rechargeable
Bluetooth wireless optical mouse with a
800/1200/1600 DPI switch button, two soft-click
buttons and scroll wheel/button for a precise and
smooth control. The ergonomic and ambidextrous
design offers maximum comfort to both
left-handed and right-handed users and helps to
increase productivity. The 300mAh built-in
rechargeable battery will power the BTTOPBAT for
up to 1-2 months before next charging is required.
No need to buy and replace batteries anymore! The
BTTOPBAT works both with Mac and PC and
doesn't require any driver.
About this guide
Before you start using the Macally BTTOPBAT,
be sure to read this guide in its entirety.
Safety intructions
Please read the following carefully before using this
Macally product. Incorrect use of this product may
result in reduced performance, permanent
damage and void warranty:
1. Do not place this product near a heat source.
2. Operating temperature of 0°C to 40°C. Storage
temperature of -20°C to 65°C.
3. Do not place this product near moisture nor
liquids.
4. Operate and store at humidity of 20% to 80%
(non-condensing)
5. Do not place heavy objects on this product.
6. Do not drop this product.
7. Do not dispose this product in the garbage. Take
it to your local recycling centre.
Package contents
• BTTOPBAT
• Charging cable
• User guide
Hardware basics
Charging port
ON
Pair
Pair
button
DPI switch (800 / 1200 / 1600)
Flashing blue = Ready to pair/Pairing
• Frequency band(s): 2402MHz - 2480MHz
• Maximum radio-frequency
power transmitted: 0.59 mW EIRP / 3.4 mA EIRP
Installation instructions
The Macally BTTOPBAT does not require a driver,
only a Bluetooth enabled computer with Mac OS X
v10.6 and later or Microsoft Windows 7 / 8 / 10, or
and iPad/iPhone with iPadOS 13/iOS 13. Simply
follow the steps below and you are ready to go!
Pairing the mouse with a Mac
1. To connect the Bluetooth mouse to your
computer, bring it within 1 ft /25 cm range from
your computer.
2. In your Mac, open 'Bluetooth' in 'System
preferences'. Make sure Bluetooth is On.
3. Then, turn on the mouse, press the pairing
button for 2 seconds until the blue light flashes
underneath the DPI switch.
4. 'Bluetooth Mouse' will appear in the list of
Bluetooth Devices. Please click on 'Connect'.
5. When 'Bluetooth Mouse' shows connected, you
are ready to use the BTTOPBAT.
1
Buttons
ON/OFF
switch
Optical
sensor
LED underneath DPI switch
Red = Charging
Flashing red = Low battery
Off = Full
Charging
Scroll wheel
/Button
cable