Publicité
Les langues disponibles
Les langues disponibles
6. Fan Assembly (flushmount). (cont)
To prepare the fan for wiring, hang fan onto
mounting plate by sliding the canopy over the
"J" hook on the mounting plate. (Use one of
the non-slotted holes on the rim of the canopy
to do so.)
Attach safety cable per instructions in last
paragraph of Section 5, page 6.
7. Wiring.
WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with
electrical wiring or if the house/building wires
are different colors than those referred to in the
diagram to the right, please use a qualified
electrician.
Note: Excess lead wire length from the fan can
be cut to the desired length and then stripped.
Once fan has been temporarily hung on the
mounting plate (refer to drawing at right), or
when downrod is secured in place on the
hanging bracket, electrical wiring can be made
as follows:
Connect BLACK and BLUE wires from fan to
BLACK wire from ceiling with wire connector
provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
canopy
motor housing
white supply wire
black supply wire
from
ceiling
black
white
white
black
blue
from fan
(wiring for fan)
page 7
mounting plate
"J" hook
ground
(green or bare)
ground
(green
or bare)
*
Publicité
