Craftmade BRD52 Guide D'installation page 6

5. Fan Assembly (with downrod). (cont.)
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to hang
your fan. Grab the fan firmly with two hands. Slide
downrod through opening in hanging bracket and let
hanging ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the hanging
bracket tab.
WARNING: Failure to align slot in hanging ball with tab
in hanging bracket may result in serious injury or
death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will
be necessary to use a heavy duty wood screw, washer
and lock washer (not supplied) with the safety cable
loop. If necessary, adjust the loop at the end of the
safety cable. The loop at the end of the safety cable
should just fit over the threads on the wood screw. Test
safety cable by pulling on loose end of cable with pliers. If
the safety cable slips, the loop must be adjusted smaller.
Extra cable slack can be left in ceiling area.
6. Fan Assembly (flushmount).
Note: Yoke cover and hanging bracket are not
used with this type of installation.
Remove and set aside canopy cover to reveal
6 holes. Notice that 3 holes are larger than the
others.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph. If
there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Thread wiring through canopy. Place canopy
over yoke, aligning larger holes in canopy with
the 3 existing screws in top of motor housing.
Insert the 3 screws and 3 lock washers that were
removed (if there were only 3 screws located in
top of motor housing, these screws/lock washer
will be located in one of the hardware packs) into
the remaining holes. Securely tighten these
screws.
wood ceiling joist
hanging bracket
yoke cover
screws/
lock washers
page 6
safety cable loop
wood screw
and washer
safety cable
hanging bracket tab
hanging ball slot
canopy
canopy cover
wiring
canopy
motor housing