Craftmade BRD52 Guide D'installation page 10

11. Wall Control Operation.
slide switch for fan
0 - fan is OFF
H - turns fan to HIGH speed
M - turns fan to MEDIUM speed
L2 - turns fan to MEDIUM-LOW speed
L1 - turns fan to LOW speed
slide switch for light
controls dimming capability for light
[Move slide switch up or down to control
light brightness.]
12. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Slide the knobs to "O" (OFF) position on
wall control. Restore power from circuit box. Test
light and dimmer function and then test fan speeds.
If fan and/or light do (does) not function, please
refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in your
comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT
for fan to function. If the reverse switch is set in the
middle position (diagram 4), fan will not operate.
slide switch
for LIGHT
(left side)
motor housing
diagram 1
diagram 2
diagram 3
page 10
FAN SPEEDS:
LOW 1 (L1)
LOW 2 (L2)
MEDIUM (M)
HIGH (H)
OFF (O)
slide switch
for FAN
(right side)
reverse switch
diagram 4