Publicité
Les langues disponibles
Les langues disponibles
User Manual
Transmitter Functionality
1. Connect the transceiver to a non-Bluetooth source device using the appropriate cable. Place the
receiver device i.e. headphones, speaker or soundbar within a 1m (3ft) range and activate this
devices Bluetooth pairing mode.
2. Push the Multi-Function switch on the front panel to the right, to the Bluetooth logo, and hold in
place. The LED indicator will flash red and blue / green to indicate the transceiver Bluetooth pairing
mode has been activated. The switch can then be released.
3. The transceiver should remain in pairing mode for approximately 30 seconds until pairing has been
successful. Once paired, the LED indicator will illuminate solid blue.
4. Please ensure the correct input connection has been used and push the multi-function switch to the
appropriate connection.
5. The devices will now be paired. This should be indicated on the receiver device with a beep, voice
indicator or otherwise. Please refer to the receiver devices manual for further information.
Multipoint Transmission
st
1. Connect the 1
device by following the above steps.
2. Push the multi-function switch to the right to re-initiate pairing mode. The LED indicator will again
flash red and blue.
3. Place the second receiver devices i.e. headphones or speaker to pairing mode. The connection will
be confirmed from the receiver device.
4. Audio will now play to both receiver devices simultaneously.
Receiver Functionality
1. Connect the transceiver to a non-Bluetooth receiver device i.e. speakers, headphones or amplifier.
2. With the transceiver powered on, switch the rear panel switch to Receiver mode. Push and hold the
Multi-function switch to the right to initiate pairing mode. The LED indicator will flash red and blue.
The switch can then be released.
3. Turn on Bluetooth pairing on the source device i.e. laptop, smartphone or tablet and go to the
Bluetooth device list.
4. Scan for new Bluetooth devices and select Lindy 70445. The LED indicator will illuminate solid blue
to confirm the connection is successful.
5. Please ensure the correct connection has been used and then push the multi-function switch to the
appropriate connection.
6. Audio can now be played from the source device via the connected audio output.
Re-connection
Once the transceiver is switched on, previously paired devices should automatically re-connect. It is
recommended that the transceiver is turned on first prior to the paired device so it can accept the
incoming connection.
Volume Adjustment
The transceiver has no volume adjustment functionality. Volume adjustment must be controlled from the
connected source or receiver device.
Factory Reset
With the transceiver powered on, slide and hold the multi-function switch to the right for approximately 6
seconds until the LED indicator illuminates a solid static colour. When the LED flashes red and blue,
release the switch. The transceiver has now re-entered pairing mode with previous connections now
cleared.
English
Publicité
