Pressure Switch - COFAN 0900 1001 Guide D'utilisation

28
5-2. ELECTRICAL
Please ensure that the air compressor is electrically connected in a safe and correct manner. Any
electrical work should be carried out by an electrician and installed in a way which meets all appli-
cable codes and regulations.
Failure to connect the air compressor correctly to power source may result in serious personal injury
or damage to the equipment.
Please note that under normal conditions, the air compressor will operate intermittently. Should it
be necessary to service, ensure the power source has been shut down to prevent personal injury
or damage to the unit.
If the supply cord is damaged, it must be replaced by the your dealer or its service agent in order
to avoid a hazard.
5-2-1. MOTOR
Wiring must be done in a manner that full voltage nameplate ±10% is available at the motor termi-
nals during startup. Use of an incorrect power source will result in premature motor failure and is not
covered by this compressor or motor manufacture's warranty.
5-2-2. THERMAL RESET SWITCH
Ensure that all guards and shrouds are in place before pressing reset switch to restart the motor.
If the motor shuts down because of overload, wait 10-15 minutes for the motor to cool down, then
press the reset switch to restart motor. The reset switch button is located on the motor housing.

5-2-3. PRESSURE SWITCH

The pressure switch acts as a pilot device activating the motor. The pressure switch cut in/cut out
has been preset at the factory, do not tamper with the settings. Never bypass or remove this switch,
as serious damage to equipment or personal injury could result from improper pressure setting.
Consult your local distributor or service center if the switch malfunctions.
ENGLISH