Pre-Operation Check; Check Engine Oil - Imer Group MASTER 6010 DXL15 YN DE Manuel D'utilisation

4. PRE-OPERATION CHECK

4.1. CHECK ENGINE OIL

Do not remove the fuel tank cap while the engine is running. Do not refuel while smoking or near
naked flame or other such potential fire hazards. Otherwise fire accident may occur.
Before checking or refilling oil, be sure generator is located on stable and level surface with engine
stopped.
•
•
Remove oil filler cap (1) and clean it using a clean cloth. Fig.
Recap the filling plug, making 1/2 turn. If the oil level is less than the minimum level (3), top up using
•
proper oil (please refer to the table) up the the maximum level mark (2). Fig.
Change oil if contaminated (See ''How-To'' Maintenance).
RECOMMENDED ENGINE OIL Fig.
Use class SE (API classification) oil or a higher grade oil according to the table below.
SAE 10W-30 is recommended for general, all temperature use. If single viscosity oil is used, select the
appropriate viscosity for the average temperature in your area.
4.2. CHECK ENGINE FUEL
Do not remove the fuel tank cap while the engine is running. Do not refuel while smoking or near
naked flame or other such potential fire hazards. Otherwise fire accident may occur.
Check fuel level at fuel level gauge. If fuel level is low, refill with GNR or diesel oil. Be sure to use the
fuel filter screen on the fuel filter neck. Fuel tank capacity: 15 L. Fig.
The diesel oil filter must be full. If it is not, perform an air bleeding.
Oil Capacity
MASTER 6010 DXL15 YN DE
TRISTAR 6510 DXL15 YN DE
MIXTE 5000 DXL15 YN DE
ARC 180 DXL15 YN DE
2
:
1
1 .
1
2 .
Upper level
1.6 L
3
EN
FR
ES
IT
RO
9