Operating Procedures; Starting The Engine; Using Electric Power - Imer Group MASTER 6010 DXL15 YN DE Manuel D'utilisation

ABOUT THE BATTERY CABLES
1. Fix the positive (+) wire connected to the electrical starter to the positive terminal of the battery.
2. Fix the negative (-) wire connected to the housing of the engine to the negative terminal of the
battery.

5. OPERATING PROCEDURES

•
Check the oil level before each operations as outlined on page 9. Never change the accelerator
•
position which is set at the factory.
Prior to operating the generator, please check that air is completely bled from diesel oil feeding pipes.

5.1. STARTING THE ENGINE

•
Turn the engine switch to the position « I » (ON). Fig.
•
Hold the key on the START position and release the key when the engine starts. Fig.
If the engine does start, do not hold the key on the Start position for more than 5 seconds, for each try..
•
If a power inverter or a remote control is used, the unit contactor must be placed on the OFF position.
Perform a no-load préheating of the engine during several minutes.

5.2. USING ELECTRIC POWER

AC APPLICATION
This generator is thoroughly tested and adjusted in the factory. If the generator does not produce the
specified voltage, consult your nearest IMER dealer or service shop.
Turn off the switch(es) of the electrical appliance(s) before connecting to the generator. Fig.
Insert the plug(s) of the electrical appliance(s) into the receptacle.
Be sure to ground the generator if the connected electrical device is grounded.
Failure to ground unit could lead to electrical shock.
•
Check the amperage of the receptacles, and be sure not to take a current exceeding the specified
•
amperage.
Be sure that the total wattage of all appliances does not exceed the rated output of the generator.
Do not put foreign objects into the plug receptacle.
9
Fig.
7
1
.
EN
FR
ES
IT
RO
7
2
.
8
11