Bertazzoni Modern Serie Manuel D'installation Et D'utilisation page 34

Failure Display and Inspection
If a fault occurs, the induction hob will enter the protection state automatically and display
the corresponding error codes:
Error
Possible Cause
Message
No pan or pan unsuitable;
ER03 Water or pan on
The connection between
Fi
the mainboard has failed
Coil temperature sensor
F3E
zone for which the indicator
Mainboard temperature
cooking zone
F4E
"E" )
Temperature sensor of the ceramic glass plate
EIE
is high
Temperature sensor of
E2 E
Abnormal supply
E3 E
Abnormal supply
E4 E
Temperature
E5 E
for which the indicator
The above are causes and solutions of the most common failures.
Do not disassemble the unit by yourself to avoid any hazards and damage to the induction
please contact the supplier.
hob, and
Technical Specifications
Cooking Zones
Supply Voltage
Installed Electric Power
Product Size LxWxH (mm)
Building-in Dimensions AxB (mm)
Weight and Dimensions are approximate. We continually strive to improve our products,
so we may change specifications and designs without prior notice.
the glass over the control
the display board and
failure. (in the cooking
is showing "E" )
sensor failure. (in the
for which the indicator is showing
the IGBT is high
voltage ( too high)
voltage (too low)
sensor failure (in the cooking zone
is showing "E")
14
What to do
Replace the pan:
Clean the user interface
Connection cable not plugged in properly
1.
or defective;
2. Replace the coil sensor if the
cable is Ok;
3. Replace the mainboard or power if the
coil sensor is OK.
Replace the coil sensor
Replace the mainboard
Please restart after the induction hob has
cooled down.
Please restart after the induction hob has
cooled down.
Please check that the power supply
normal;
Power on when the power supply
Please check that the power supply
normal;
Power on when the power supply
Connection cable not plugged in properly or
defective assembly;
2 Zones
220–240V~
3500W
300x520x60
265x495
connection
is
is normal.
is
is normal.