Standard Accessories; Applications; Mounting And Operation - HIKOKI DV 16V Mode D'emploi

English
Rotation only function
Rotation and impact function
Switching ON
Switching OFF
On / Off switch lock-on
Disconnect mains plug from electrical outlet
Class II tool

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package
contains the accessories listed in the below.
(1) Chuck wrench (Spec. only for chuck fi tted with chuck
wrench) ........................................................................1
(2) Side handle ..................................................................1
(3) Depth stopper ..............................................................1
(4) Plastic case ..................................................................1
Standard accessories are subject to change without notice.

APPLICATIONS

○ By combined actions of ROTATION and IMPACT:
Boring holes in hard materials (concrete, marble, granite,
tiles, etc.)
○ By ROTATIONAL action:
Boring holes in metal, wood and plastic.
SPECIFICATIONS
Voltage (by areas)*
1
Power input
No load speed
Drill chuck capacity
Steel
Capacity Concrete
Wood
Full-load impact rate
Weight (without cord)* 2
*1 Be sure to check the nameplate on product as it is
subject to change by areas.
*2 According to EPTA-Procedure 01/2014.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
(110 V, 220 V, 230 V, 240 V)
590 W*
1
0 – 2900 min
-1
13 mm
13 mm
16 mm
25 mm
34500 min
-1
1.9 kg

MOUNTING AND OPERATION

Action
Fixing and removing side handle
Using depth stopper
Mounting and dismounting of
the bit
Dismounting the bit of keyless
chuck (When the keyless chuck
cannot be loosened)
Selecting rotation direction
Selecting the operating mode
Switch operation
Locking-on the switch
Releasing the switch
Mounting position of hook (A)*
(Optional accessory)
Selecting accessories
* Attaching the hook. (Optional accessory) (Fig. 10)
(1) To attach the hook, it is necessary to disassemble
the handle portion which covered the tool's electrical
system. For your continued safety and electrical
shock protection, installing the hook on this impact
drill should ONLY be performed by a HiKOKI
AUTHORIZED SERVICE CENTER.
(2) When the power tool is used with a hook fixed to it,
pay attention to the following points:
○ Before hanging the main unit from the waist belt, make
sure that the impact drill has come to a complete stop.
While it is suspended from the waist belt, the power
plug must be disconnected from the power source.
○ Do not walk about with the power tool hanging from
the waist belt.
○ In the case of operation in a high place, it is dangerous
to drop the tool accidentally. If the hook is deformed or
hung from the wrong position, there is danger that the
hook will slip off and the tool will fall.
Be careful to avoid danger.
○ In making a through hole, the power tool sometimes
shakes violently when the workpiece is pierced, from
example. Be careful you are not hurt by the hook even
if such situation happens.
Selecting the appropriate drill bit
○ When boring concrete or stone
Use the drill bits specifi ed in the Optional Accessories.
○ When boring metal or plastic
Use an ordinary metalworking drill bit.
○ When boring wood
Use ordinary woodworking drill bit.
However, when drilling 6.5 mm or smaller holes, use a
metalworking drill bit.
4
Figure Page
1
95
2 95
3
95
4
95
5 96
6
96
7
96
8
96
9
96
10 96
― 98