Hunter 90408 Manuel Du Propriétaire page 5

All manuals and user guides at all-guides.com
operatIon
This appliance is for household use
only.
1. Place the fan on a dry, safe, flat
surface where it cannot fall or
be pulled by the cord.
2. Plug the fan into a grounded
120-volt AC electrical outlet
(ordinary household current).
DO NOT use any other type of
outlet. Make sure that the rated
voltage of the fan is the same
as the power source before
plugging it into the power
source.
3. Turn the fan "ON" or "OFF"
by turning the Power/Speed
Control knob. The power
should always be OFF before
unplugging the fan.
Power/Speed
Control Knob
4. To select the speed, turn the
Power/Speed Control knob
from OFF to the desired speed
setting: O (off), I (low), II
(medium), III (High).
5. To control the upward and
downward direction of airflow,
loosen the screw on the side of
the fan housing neck. Adjust to
the desired angle and tighten
the screw.
6. To make the fan oscillate,
push the oscillation knob
down. To stop oscillating, pull
the oscillation knob up. The
oscillation knob is located on
the top of the fan housing, near
the handle.
Handle
Up/Down
Adjustment Screw
fIGure 3
5
Oscillation Knob
Motor Housing
Base