Panasonic ER‑GK80 Mode D'emploi page 16

►With water
To remove light dirt
1. Remove the
attachment and turn
the main body on.
(See page 14.)
2. Run water down the
water inlet at the back
of the main body, rinse
thoroughly for
approximately 20
seconds, and then turn
the main body off.
• Shake up and down several times to remove the
water.
• Be careful not to hit the main body on the sink or
any other object while draining the water. Failure
to do so may cause malfunction.
16
PB017156 - ER-GK80 _(01GB)_12-05-18.indd 16
To remove heavy dirt
1. Remove the
attachment and blade.
(See pages 14 and 17.)
2. Clean the main body,
the blade and the
attachments with
running water.
3. Wipe off the water with a towel
and let it dry naturally.
• It will dry faster with the blade
removed.
4. Apply the oil to the blade after
drying. (See page 17.)
5. Attach the blade and the skinguard attachment to
the main body.
• Be sure to place the skinguard attachment on the
main body to protect blade when storing.
►With the brush
1. Remove the attachment and blade.
(See pages 14 and 17.)
2. Clean the main body using the brush.
3. Clean the blade using the
brush.
• Keep pressing down the
cleaning lever ( ) to raise
c
the moving blade ( ) when
d
cleaning between the
stationary blade ( ) and the
e
moving blade.
4. Apply the oil to the blade. (See page 17.)
5. Attach the blade and the skinguard attachment to
the main body.
• Be sure to place the skinguard attachment on the
main body to protect blade when storing.
c
e
d
2018/12/6 16:47:23