Maintenance - Panasonic ER‑GK80 Mode D'emploi

Trimming height comb attachment
• The digit on the attachment indicates the target
trimming length.
• Actual hair length will be a little longer than the height
you set.
• The desired results may not be achieved if hair is too
long.
In this case, trim the hair to a length of about 20 mm
before using the appliance.
• Hair will be easy to accumulate in the attachment
when a lot of hair is cut. When this happens, clean the
attachment. (See pages 15 and 16.)
1
Turn the dial and adjust the
trimming height indication mark
( ) to the desired height.
b
• Trimming height:
approx. 3 mm to 12 mm
2
Apply the flat part of the comb against your
skin and cut your hair by combing it left and
right.
PB017156 - ER-GK80 _(01GB)_12-05-18.indd 15

Maintenance

Cleaning
• Clean the main body and the blade after each use.
(If not cleaned, the motion will become poor and the
sharpness will worsen.)
• Do not use thinner, benzine, alcohol or other
chemicals. Doing so may cause failure, cracking or
discoloration of the main body. Wipe the main body
only with a soft cloth slightly dampened with tap water
or soapy tap water.
• Make sure that the main body is turned off.
• Remove the main body from the AC adaptor.
b
Flat part of the comb
15
2018/12/6 16:47:22