Samsung ZR20 Serie Manuel D'utilisation page 13

operating your freezer
ADJUSTING THE TEMPERATURE
CONTROL
Normal
3
2
Cold 1
o
Comp Fast
Activation Freezing
• To adjust the temperature inside the freezer
compartment, adjust the temperature control
dial on front-bottom side of the chest freezer.
Normally use chest freezer with temperature
Normal.
If the cooling performance is inadequate, turn
the temperature control in the direction of 7. If it
is too cold, turn the dial in the direction of 1.
• When you need the unit to stop running
temporally, please turn the temperature control
dial in the direction of off.
- fast freezing : If you store large quantities of
food, or want to make food freeze faster, turn
the 'Fast Freezing' button On.
Do not keep the fast freezing button On for
long.
- power : When the light is on, power is on.
- comp activation : when the light is on,
compressor is working.
• If the temperature where the Freezer
is placed is lower than 5 °C, set the
temperature control to COLD. Because
the temperature of the Freezer is
affected by the temperature around the
Freezer and it will be lower than the set
value.
• Apart from knob settings mentioned above, if
you desire to increase or reduce the cooling,
turn the knob clockwise or anticlockwise to the
degrees you want.
HOW TO DEFROST
1. Check the layer thickness of the frost/ice
2. Set the thermostat to "coldest" at least 12 hour
5
3. After this period has elapsed, switch off the
6
4. Remove all food from freezer and wrap them in
7 Coldest
5. When the defrosting is finished, the
6. After defrosting , defrost water can flow out
Power
7. In order to remove ice from the ice making
English - 13
formed on the walls of the compartment.
If frost is formed more than 4mm, please
defrost.
before defrosting.
freezer compartment by removing the plug
from the main power supply.
paper and store them in a cold place and leave
the door open.
compartment must be cleaned and wiped dry.
through the drain once you open the drain
cap in/out side of the freezer.
compartment, do not use a keen tool, knife or
screw driver.