Texas PowerLine TG500B Manuel De L'utilisateur page 14

2. Assembly
1. Fasten the engine securely onto the base.
2. Make sure that the engine's PTO is on a straight line with the receiver's PTO.
Engine – Machine.
An uneven PTO will result in the engine not pulling correctly and being damaged.
If problems arise or if you have any questions regarding the assembly of your
Power Line engine, you are always welcome to contact your Power Line dealer.
3. Oil / changing oil
By 20° C
SAE 30
Always check the oil level when the engine is placed in a horizontal position.
Always check the oil level without fastening the oil stick.
TG500B / TG650B
Oil should be changed in accordance with the user manual for the machine.
1. Let the engine run 5 minutes, so that the oil is heated. This makes the oil flow more
easily and it is easier to complete the oil change.
2. After 5 minutes the engine is turned off. Unscrew the engine's oil drain plug and the
oil runs out of the engine. Remember to keep an appropriate container ready.
3. Put the drain plug back in its place and new oil is added to the engine.
4. You add oil by removing the oil stick and adding the correct amount of oil.
Remember to dispose the used oil so that you are of no nuisance to the nature.
4. Fuel
Only use unleaded octane 95 fuel on your engine and the right capacity.
Never overflow the tank with gasoline. On the tank an indicator is places
TG500B / TG650B
PROCEDURE
QUESTION
Use the correct oil for the specific time of year.
10-20° C
OIL CAPACITY
CHANGING OIL
Use your local recycling station.
which shows the amount of remaining fuel.
See figure 10 on page 5.
OIL
SAE 20
FUEL
14
Below 10° C
SAE 10W - 30
0.6 l
3.6 l