Installation; Door Reversibility - Zanussi ZRB22130WA Manuel D'utilisation

Installation

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Climatic class
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
Location
The appliance should be installed as far away
as possible from sources of heat such as
radiators, boilers, direct sunlight etc. Ensure
that air can circulate freely around the back
of the appliance. If the appliance is installed
below an overhanging wall unit, the minimum
distance between the top of the appliance
and the wall unit must be at least 100 mm
to guarantee the best possible performance.
Accurate levelling is ensured by one or more
adjustable feet at the base of the cabinet.
Warning! It must be possible to
disconnect the appliance from the main
power supply; therefore the plug must
be easily accessible after installation.
Electrical connection
Caution! Any electrical work required
to install this appliance may only be
carried out by a qualified electrician or
qualified person.
Warning! The earthing of the appliance
is prescribed by law. The manufacturer
accepts no responsibility if the safety
measures set out in this manual are
disregarded.
10
Ambient Temperature
Levelling
The appliance must be level in order to pre-
vent vibrations. To level the appliance, it must
be upright and both adjustable feet must be
touching the floor. You can also level the ap-
pliance by unscrewing the front feet (you can
do this manually or with a suitable spanner).

Door reversibility

The side at which the door opens can be
changed from the left side (as supplied) to the
right side. Before you start to do this, lay the
refrigerator on its back to access the base.
Place the refrigerator on soft foam packaging
material or other similar material so that the
cooling pipes at the back of the refrigerator
are not damaged.
1. Stand the refrigerator up and use a flat
blade screwdriver to remove the four
screw covers at the rear of the refrig-
erator cover.
2. Unscrew the cover and then lift it to
remove the back panel. Then, lift the
upper door and place it on a padded
surface to prevent it from being
scratched.
www.zanussi.com