Room Temperature - Mitsubishi Electric CITY MULTI PKFY-P NLMU Série Manuel D'utilisation

2. Parts Names
Display
The main display can be displayed in two different modes: "Full" and "Basic". The factory setting is "Full". To switch to the "Basic" mode, change the
setting on the Main display setting. (Refer to operation manual included with remote controller.)
<Full mode>
* All icons are displayed for explanation.
$ 2 3
#
6
7
8
Room
9
0
Cool Set temp.
1
1
Mode
!
▌1 Operation mode
▌2 Preset temperature
▌3 Clock
▌4 Fan speed
▌5 Button function guide
Functions of the corresponding buttons appear here.
▌6
Appears when the ON/OFF operation is centrally controlled.
▌7
Appears when the operation mode is centrally controlled.
▌8
Appears when the preset temperature is centrally controlled.
▌9
Appears when the filter reset function is centrally controlled.
▌0
Indicates when filter needs maintenance.
▌1 Room temperature
▌2
Appears when the buttons are locked.
▌3
Appears when the On/Off timer or Auto-off timer function is enabled.
appears when the timer is disabled by the centralized control
system.
appears when the HOLD function is enabled.
4 5 6 7 8
Fri
83
Auto
83
Temp. Fan
2
5
<Basic mode>
$
3
#
9
@
Cool
)
1
4
Mode
▌4
Appears when the Weekly timer is enabled.
▌5
Appears while the units are operated in the energy-save mode. (Will
not appear on some models of indoor units)
▌6
Appears while the outdoor units are operated in the silent mode.
(This indication is not available for CITY MULTI models)
▌7
Appears when the built-in thermistor on the remote controller is
activated to monitor the room temperature (1).
appears when the thermistor on the indoor unit is activated to
monitor the room temperature.
▌8
Indicates the vane setting.
▌9
Indicates the louver setting.
▌)
Indicates the ventilation setting.
▌!
Appears when the preset temperature range is restricted.
▌@
Appears when an energy-saving operation is performed using a "3D i-See
sensor" function.
▌# Centrally controlled
Appears for a certain period of time when a centrally-controlled item is
operated.
▌$ Preliminary error display
An error code appears during the preliminary error.
Most settings (except ON/OFF, mode, fan speed, temperature)
can be made from the Main menu. (Refer to Page 9.)
2
Fri
Auto
Set temp.
83
Temp. Fan
5
3
4
en
4