Replacing Carbon Brushes; Optional Accessories - Makita HHU01 Manuel D'instruction

Install the plate, under cover on the tool. Tighten the
screw firmly.
NOTE:
There is no distinction between the top and bottom
•
of the plate.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades does not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1
011161
Insert the top end of slotted bit screwdriver into the
notch in the tool and remove the holder cap cover by
lifting it up.
1
011162
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1. Limit mark
1
1. Holder cap
cover
2. Screwdriver
2
1. Brush holder
cap
2. Screwdriver
2
Reinstall the holder cap cover on the tool.
Storage
The hook hole in the bottom of the blade cover is
convenient for hanging the tool from a nail or screw on
the wall.
011160
Remove the battery cartridge and put the blade cover
on the shear blades so that the blades are not exposed.
Store the tool out of the reach of children carefully.
Store the tool in the place not exposed to water and rain.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Blade cover
•
Shear blade assembly
•
Makita genuine battery and charger
•
Battery converter BCV02
•
Chip receiver
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
11
or attachments
Only use accessory or
are