Réglementation (En Anglais Uniquement) - Xerox Phaser 4400 Guide De Support

Réglementation
(en anglais uniquement)
The equipment described in this manual generates and uses radio frequency energy. If it is not installed
properly in strict accordance with Xerox's instructions, it may cause interference with radio and
television reception or may not function properly due to interference from another device. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiver (device being interfered with).
I
Increase the separation between the printer and the receiver.
I
Connect the printer into an outlet on a circuit different from that which the receiver is connected.
I
Route the interface cables on the printer away from the receiver
I
Consult the dealer, Xerox service, or an experienced radio/television technician for help.
I
Changes or modifications not expressly approved by Xerox can affect the emission and immunity
compliance and could void the user's authority to operate this product. To ensure compliance, use
shielded interface cables. A shielded parallel cable can be purchased directly from Xerox at:
www.xerox.com/officeprinting/4400supplies.
Xerox has tested this product to internationally accepted electromagnetic emission and immunity
standards. These standards are designed to mitigate interference caused or received by this product in a
normal office environment. This product is also suitable for use in a residential environment based on
the levels tested.
In the United States this product complies with the requirements of an unintentional radiator in part 15
of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference; (2) this device must accept any interference received, including interference that
may cause undesired operation.
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications, NMB-003.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numériques de la classe B prescrites dans le Réglement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada, NMB-003.
Copyright © 2002, Xerox Corporation. Tous droits réservés.
Imprimante laser Phaser™ 4400
16