Rowenta JA10 Serie Guide De L'utilisateur Et Instructions De Sécurité page 10

IS THERE A PROBLEM ?
Problems
Blades do not turn
when switch on
Motor low speed
Efficiency is not perfect
10
Possible cause
Metal grid blades guard is not
fully screwed.
Battery low power or lose
performance.
Battery install Upside-Down.
Battery is the wrong model.
Battery low power or lose
performance.
Lint tank is full.
Blade support is stuck by lint.
Metal grid blades guard is not
fully screwed.
Grid metal blade guard is
deformed.
Blade support is not well located.
Height is not adapted to the lint.
Motor speed is low
Solutions
Fully screw the metal grid
blades guard.
Replace battery
Reset in + and - locations.
Check contacts not deform
Replace by AA (LR6) 1.5V
Check contacts not deform.
Replace battery.
Empty tank
Remove grid.
Clean up blade support by
brush use.
To check grid full screwed
To check grid.
Unscrew metal grid blades guard.
Check that the blades support is
fully inserted in its axis.
Adjust the shaving height by
turning the height adaptor.
Check batteries.
Check Lint tank.
.