Connections And Settings - CAME DXR20SAP Instructions Pour L'installateur

C
Installation
1
Make a hole in the board box and thread the electrical cables through the hole.
Position the control board at the correct angle.
The maximum range is 180° horizontally and 10° vertically.
2
Secure in place using the screws for the rotating support and electronic board.
3
Attach the front cover.

Connections and settings

Use FROR cables 2 x 0.5 mm.
D
Connecting a pair of photocells.
E
Connecting two pairs of photocells.
F G
Connecting multiple pairs of photocells (max. 8).
Set each pair of RX-TX photocells with its own address via the DIP-switches
(1-2-3).
Use DIP-switch (4) on the TX photocell to set the range; 10 m (4 set to OFF) or 20 m (4
set to ON)
Use DIP-switch (4) on the RX photocell to set the normal operating mode (4 set to OFF) or
alignment / check BUS communication operating mode (4 set to ON).
After checking the alignment and BUS communication, set DIP-switch 4 on the
RX photocell back to OFF.
For installations alongside photocells of a diff erent type, we recommend
installing TX transmitters and RX receivers alternately, as shown in the fi gure
E