Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 2: Install the Pedals.
Secure the Left and Right Pedals (17, 18) to the Crank (16) respectively,
viewed from the rider's seated position.
Note: Both pedals are labeled L FOR LEFT and R FOR RIGHT. To
tighten turn the left pedal COUNTERCLOCKWISE and the right pedal
CLOCKWISE.
Step 3: Install the Handlebar Post.
Connect the Sensor wire (22) to the Upper Sensor Wire (21). Then,
Connect the Tension Control Cable (20) to the Tension Controller
(19), make sure it has been connected correctly as shown.
Insert the Handlebar Post (4) over the Main section (1), secure in place
with the Bolts (8) and Arc Washers
(13) which are pre-attached to the
Main Section.
★ Ensure that ALL bolts and
washers are in place and partially
threaded
in
before
completely
tightening any ONE bolt .
Publicité
Table des Matières
