Application Area; Environmental Conditions; Safety Information - Renfert hotty LED Mode D'emploi

1 Introduction
Thank you for purchasing our hotty LED wax dipping unit.
Please observe the following notices, they will help provide you a long and problem free lifetime of your
wax dipping unit.
2

Application area

The hotty LED is an electronically regulated wax dipping pot. It is ideally suited for melting and retaining
any conventional dipping wax.
The hotty LED shows its quality in use when it comes to the following points:
The precise temperature control
(+/- 2 °C [3.6 °F]) provides you with a very constant quality of copings. Together with the heating unit,
which reacts to the environmental temperature, this excludes the possibility of over heating and conse-
quent damage to the dipping wax.
Please be aware that the initial heating process is very gentle to the dipping wax and it may take some
time before the wax if fully melted. Thanks to a slow continual increase of the working temperature,
there is no chance that the temperature inside the pot will exceed the set point.
The hotty LED offers you optimal working conditions. The housing is designed to let both left and right-
handed people rest their hand on the working table whilst dipping. In addition, the lid of the wax-dipping
unit can be moved completely out of the working area.
2.1

Environmental conditions

(In accordance with EN 61010-1)
The unit may only be operated:
• Indoors;
• Up to an altitude of 2,000 m [6,500 ft] above sea level;
• At an ambient temperature of 5 - 40 °C [41 - 104 °F]
• At a maximum relative humidity of 80 % at 31 °C [87.8 °F], decreasing linearly to 50 % relative humidity
at 40 °C [104°F]
• With a mains power supply where current fluctuations do not exceed 10 % of the nominal value;
• Under level 2 contamination conditions;
• Under overvoltage category II conditions.
*) Between 5 – 30 °C [41 - 86 °F], the unit can be operated at a relative humidity of up to 80 %. At temperatures
between 31 - 40 °C [87.8 - 104 °F], the humidity must decrease proportionally in order to ensure operational readi-
ness (e.g., at 35 °C [95 °F] = 65 % humidity; at 40 °C [104 °F] = 50 % humidity). The unit may not be operated at
temperatures above 40 °C [104 °F].
3

Safety Information

hotty LED is an electrical appliance with a danger potential. This appliance may be connected /
used only by authorized and qualified persons after checking its conformity with respect to the
national norms.
Before initial use, check the voltage recommendations on the name plate (rear side of the unit)
and compare with the mains supply.
Units with damaged power cables or other defects are not to be used.
Mains supply cable (C) must be unrolled when in use (danger of over heating in the event of short
circuit).
Molten wax can cause severe burns to the skin. Do not move the unit once in operation.
The wax melting pot (F) heats up during use right to the rim. Incorrect use can lead to burns, even
30 min. after the unit has been switched off.
The hotty LED is only intended for use with conventional dental dipping wax. Under no circum-
stances should it be filled with other materials.
Please remember: overfilled pots can easily overflow!
;
*)
;
*)
EN