Technical Parameters - LUND 79415 Manuel D'instructions

PROPERTIES OF THE TOOL
The manual electric plane for wood is an ordinary electric tool, insulation class II, designed for planing, bevelling and forming
rebates in wood and wood-derived materials. The tool permits to adjust the depth of planing, and it is equipped with a guide and
a ferrule to extract dust and shavings. Under no circumstances should the tool be used for other materials than wood. A correct,
reliable and safe functioning of the electric tool depends on its proper use, so:
Before you proceed to operate the device, read the manual thoroughly and keep it.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
EQUIPMENT
The factory box should contain the following:
- plane
- terminal of the dust extraction ferrule

TECHNICAL PARAMETERS

Parameter
Catalogue number
Mains voltage
Mains frequency
Nominal power
Rotation (idle)
Depth of planing
Maximum width of planing
Mass
Level of noise
acoustic pressure
acoustic power
Level of vibration
Insulation class
Protection grade
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and
moving elements. Damage to the power supply cable increases the risk of an electric shock.
In case work is realised outside closed areas, it is necessary to use extension cords designed for applications outside
O R I G I N A L
GB
Unit of measurement
[V~]
[Hz]
[W]
[min ]
-1
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
[m/s ]
2
I N S T R U C T I O N S
Value
79415
230
50
480
16000
0 - 0,6
82
1,85
85,0 ± 3,0
96,0 ± 3,0
6,63 ± 1,5
II
IP20
11