Stand Mounting - Omni International GLH 850 Manuel D'utilisation

Cross Rod
Port
1. Assemble the stand (sold separately).
2. Insert the cross rod into the cross rod
port at the back of the unit and tighten
thumb screw by turning clockwise
until tight.
3. Loosen the second knob on the post
clamp and insert the cross rod with
motor attached (approximately 1"
of the cross rod should protrude from
the back of the post clamp).Lock in place.

Stand Mounting

Cross Rod
Thumb Screw
Clamp
Stand
Part No. S1000
(sold separately)
1"