ASROCK B660M-HDVP/D5 R2.0 Mode D'emploi page 25

Chassis Intrusion and
Speaker Header
(7-pin SPK_CI1)
(see p.1, 2, No. 10)
Serial ATA3 Connectors
Vertical:
(SATA3_0:
see p.1, 2, No. 8)
(SATA3_1:
see p.1, 2, No. 9)
(SATA3_2:
see p.1, 2, No. 7)
(SATA3_3:
see p.1, 2, No. 6)
USB 2.0 Headers
(9-pin USB_3_4)
(see p.1, 2, No. 15)
(9-pin USB_5_6)
(see p.1, 2, No. 14)
USB 3.2 Gen1 Header
(19-pin USB3_1_2)
(see p.1, 2, No. 5)
22
SPEAKER
DUMMY
DUMMY
+5V
1
SIGNAL
GND
DUMMY
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
Vbus Vbus
Vbus IntA_PB_SSRX-
IntA_PA_SSRX- IntA_PB_SSRX+
IntA_PA_SSRX+ GND
GND IntA_PB_SSTX-
IntA_PA_SSTX- IntA_PB_SSTX+
IntA_PA_SSTX+
GND
GND IntA_PB_D-
IntA_PA_D- IntA_PB_D+
IntA_PA_D+ Dummy
1
Please connect the
chassis intrusion and the
chassis speaker to this header.
These four SATA3 connectors
support SATA data cables for
internal storage devices with
up to 6.0 Gb/s data transfer
rate.
*If M2_1 is occupied by
a SATA-type M.2 device,
SATA3_0 will be disabled
(for H610M-HDVP/D5 R2.0
only).
There are two USB 2.0 headers
on this motherboard.Each
USB 2.0 header can support
two ports.
There is one USB 3.2 Gen1
header on this motherboard.
This USB 3.2 Gen1 header can
support two ports.