Roger Technology B70/1DC Instructions Et Consignes Pour L'installateur page 72

5. Press TEST (see TEST mode in chapter 10) and check the command signal and safety device states. If any safety
devices are not installed, jumper the relative contact or disable the device from the relative parameter ( ,
, and ).
TEST
1 click
CLOSE
11.2
Acquisition procedure:
PROG
AP P-
x4 s
OPENING OPEN
• Press and hold PROG for 4 seconds.
• Open the release handle. The message
launches a calibration procedure. The operating parameters of the motor are determined during calibration.
• If the motor calibration procedure is successful, the message
• Close the release handle. The acquisition procedure now starts.
• is shown on the display (only if parameters
beam within 5 s, to prevent interrupting the procedure.
• is shown on the display and the gate starts opening at low speed.
•
• The gate closes until it reaches the gate closed limit switch.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
• : calibration procedure failed.
• : acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
• : travel length error. Press the TEST button to clear the error, and check that gate is completely closed.
ATTENTION: if the acquisition procedure was successful BUT the space between the leaf (stopped at the limit
switch) and the mechanical stop is not as desired, move the limit switch and REPEAT THE ACQUISITION
PROCEDURE. Ensure that AT LEAST 3 centimetres remain between the leaf stop and the mechanical stop.
For more information, see chapter 17 "Alarms and faults".
72
TEST
15 15
No
TEST
da da ta ta
No
YES
TEST
fC fC
PH A5
PH A5 PH A5
Wait ...
AU AU to to
is shown on the display.
appears on the display after a few seconds. The controller unit
, ,
SEE CHAPTER 16 and 17
1 click
Until ...
PROG
AP P-
1 click
Press and hold on
ACQUISITION
PROCEDURE
CHAP. 11.2
1 click
FO TO FO
(if FT input are
connected or enabled)
CLOSING CLOSE
, are not disabled). Keep away from the photocell
, ,
ACQUISITION
PROCEDURE
CHAP. 11.2
TO
AU to
Yes