Traxxas 6541 Instructions D'installation

High-Current Connector Power Tap Installation Instructions
Kit contents:
• Power tap
• Power tap cover
• 2.6x8mm button-head cap screws (2)
Tools needed:
• 2.0mm hex wrench
CAUTION: RISK OF DAMAGE
TO BATTERIES!
Do not attach the power tap to the battery connector.
Attach to the electronic speed control (ESC) connector
only. Always disconnect the battery from the ESC when
not in use to prevent the possiblity of over-discharge.
CAUTION: RISK OF DAMAGE
TO ACCESSORIES!
and wire color on the pre-installed wires on the power tap.
Ensure the polarity is correct during installation on the
High-Current Connector: red (+) (positive), black (-)
(negative).
Installation:
1. Attach the power tap to the High-Current Connector of
the electronic speed control (ESC) on your model.
2. Install the cover on the power tap using the included
2.6x8mm BCS (2).
If you have questions or need technical assistance, call Traxxas at
1-888-TRAXXAS
(1-888-872-9927) (U.S. residents only)
Traxxas, 6250 Traxxas Way, McKinney, TX 75070, Phone: 972-549-3000, Fax: 972-549-3011, e-mail: support@Traxxas.com
HKC20062-R03_6541X-6549_Power Tap Installation Instructions-ML-201027.indd 1 HKC20062-R03_6541X-6549_Power Tap Installation Instructions-ML-201027.indd 1
DO NOT install the power tap on vehicles with
dual battery configurations. Incorrect installation
of the power tap on the High-Current Connector
will cause one of the batteries to short circuit,
damage the electronic speed control (ESC), and
damage the batteries.
1
During installation, be sure that
the terminals of the High-Current
Connector and the power tap
make full contact.
ESC Wiring
Note the polarity
Power Tap
ESC Wiring
TR AXXA S.c om
Covers Parts #6541X, 6549
Wire colors mismatched
High-Current
Connector
2
2.6x8mm BCS
(self-tapping)
ESC
Power Tap
HKC20062-R03
Burn hazard.
Hot wires.
Do not touch.
Burn hazard.
Hot wires.
Do not touch.
ESC Power
Tap Cover
Rev 201027
10/27/20 5:09 PM 10/27/20 5:09 PM