GreenWorks GD40CS15 Manuel Opérateur page 7

EN
1 DESCRIPTION
1.1 PURPOSE
This chainsaw is designed for cutting branches, trunks,
logs and beams of a diameter determined by the cutting
length of the guide bar. It is only designed to cut wood.
It is only to be used in an outdoor, domestic application
by adults.
Do not use the chainsaw for any purpose not listed
above.
This chainsaw is not to be used for professional tree
services. It is not to be used by children or by persons
not wearing adequate personal protective equipment
and clothing.
1.2 OVERVIEW
Figure 1-15.
Guide bar cover
1
Front handle
2
guard / chain brake
Front handle
3
Lock out button
4
Trigger
5
Oil tank cap
6
Oil indicator
7
Spike bumpers
8
Saw chain
9
10 Guide bar
11 Wrench
12 Rear handle
13 Chain tension
screw
14 Chain cover
15 Chain cover nuts
16 Bolt for saw chain
tension
17 Sprocket
18 Battery release
button
19 Oil outlet
20 Bar groove
21 Chain drive links
22 Cutter
23 Felling direction
English
24 Danger zone
25 Escape route
26 Direction of fall
27 Notch
28 Felling back cut
29 Hinge
30 Limb cut
31 Keep work off
ground leave
support limbs until
log is cut
32 Log supported
along the entire
length
33 Cut from top (over
buck) avoid cutting
earth
34 Log supported one
end
35 Under buck
36 Over buck
37 Log supported both
ends
38 Bucking a log
39 Stand on uphill
side when cutting
because log may
roll
2 GENERAL POWER TOOL
SAFETY WARNINGS
WARNING
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
3 INSTALLATION
WARNING
Do not change or use accessories that are not
recommended by the manufacturer.
WARNING
Do not install battery pack until you assemble all the
parts.
3.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If parts of the machine are damaged, do not use
the machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
3.2 ADD THE GUIDE BAR AND CHAIN
OIL
Figure 1.
Examine the amount of oil in the machine. If the oil level
is low, add the guide bar and chain oil as follows.
4