Télécharger Imprimer la page

GreenWorks GD40CS15 Manuel Opérateur page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 43
EN
During the process,
Keep the file flat with the surface to be sharpened.
Use the midpoint of the file bar.
Use light but firm pressure when sharpening the
surface.
Lift the file away on each return stroke.
Sharpen the cutters on one side and then move to
the other side.
Replace the chain if:
The length of the cutting edges is less than 5 mm.
There is too much space between the drive links
and the rivets.
The cut speed is slow
Sharpening the chain many times but it does not
increase the cutting speed. The chain is worn.
5.3
GUIDE BAR MAINTENANCE
Figure 15.
Make sure that it is turned over periodically to keep
symmetrical wear on the bar.
1. Lubricate the bearings on the nose sprocket (if
present) with the syringe (not included).
2. Clean the bar groove with the scraping hook (not
included).
3. Clean the lubrication holes.
4. Remove burr from the edges and level the cutters
with a flat file.
Replace the bar if:
the groove is not fit with the height of the drive links
(which must never touch the bottom).
the inside of the guide bar is worn and make the
chain lean to one side.
6
TRANSPORTATION AND
STORAGE
Before you move the machine, always
Remove the battery pack from the machine.
Keep hands clear of the lock-out button.
Put the guide bar cover on the guide bar and the
chain.
Before you put the machine into storage, always
Remove all residual oil from the machine.
Remove the battery pack from the machine.
Clean all unwanted material from the machine.
Make sure that the storage area is
NOTE
NOTE
English
Not accessible for children.
Away from agents which can cause corrosion,
such as garden chemicals and de-icing salts.
8

Publicité

loading

Ce manuel est également adapté pour:

Csf403