Nussbaum POWER LIFT HL 2.50 NT Manuel D'exploitation page 53

• Set up and position the lift.
• Fasten cross-beams above on the lifting columns.
• Holes for floor anchoring (3) are to be made
through the holes in the base plates (2).
Clean the bore holes by blowing them out with
air. Insert safety anchors into the holes (also see
4.4 Selecting anchor).
• Connect colour marked hydraulic lines
(see Section 11.1).
• Before anchoring the lift, check whether the con-
crete is of quality C20/25 up to the finishing level
of the completed floor. In this case, take the an-
chor length from the anchor manufacturer's data
sheet.
If there is a floor covering (tiles, screed) on the
!
weight bearing concrete, the thickness of this
covering must be determined. Afterwards, take
the anchor length from the anchor manufactur-
er's data sheet.
• Position and align the lift and lift columns using a
bubble level.
1
2
Anchoring
1 Column
2 Base plate
3 Positioning the fastening anchor
• The base plates (2) are also to be supported with
suitable underlays (thin metal strips) to ensure
precise vertical set up and contact between the
base plate and the floor.
• Tighten the anchors using a torque wrench.
Each anchor must be able to be tight-
ened to the torque specified by the
manufacturer. Safe operation of the lift
is not guaranteed with a lower torque.
20110002 POWER LIFT HL 2.50 NT - HYMAX HL 5000 PH OPI
4.7
4 Riser extension (optional)
5 existing riser
Riser extension (4) is set on the existing riser (5). The
3
open side faces inwards.
4
023
4 Riser extension (optional)
• Set to the desired height (from 100 mm to 900 mm
in 100 mm steps).
I i Please consider the maximum ceiling height!
• Guide the 4 hydraulic lines that are fastened to
the operating columns upwards out of the ris-
er. Afterwards, fasten the cover (6).
Version 1.0
Riser extension (optional)
4
5
001
003
53