Intended Use; Hot Laminating - ACROPAQ AL420 Notice D'utilisation

EN

Intended Use

This laminator has been conceived for use processing hot and cold
laminating foil. It is possible to laminate pictures, maps, documents, paper
etc. up to a total thickness of 0.5 mm. Any other use is considered
unintended use. Unauthorised modifications or reconstructions are not
permitted.

HOT Laminating

1. Connect the power cable to an easily accessible, standard electrical
socket. Caution: Check that the voltage specifications of the unit
correspond to that of your power supply network (220 - 240 V, 50 Hz).
2. Use the on/off switch on the right of the appliance to switch on:
"ON"
3. The drive motor for the transport rollers starts up. The correct
operating temperature is reached after about 1.5-2 minutes and the
'READY'-indicator becomes red.
4. Insert the document to be laminated in the pouches so that there is
a margin of approx. 3 - 5 mm to the edge of the foil on all sides.
Caution: Only use foil intended for hot laminating.
5. Insert the foil containing the document in the laminator's insertion
slot. Insert the ready closed side of the pouch first.
Note: To prevent the laminating foil from creasing, never insert the
open end of the foil pocket in the insertion slot of the laminator first.
When inserting the foil, observe the instructions on the insertion slot.
The laminating process occurs automatically.
Caution: The foil is very hot and soft when ejected following lamination.
Therefore, handle the laminated product with extreme care.
TIP: To flatten the laminated product, place a book or similar heavy,
flat object, on it.
User Manual AL420-AL320-AL490-AL390
5
AL490 - AL390
pg 4