Machine Set Up Guide; Fitting The Brush / Pad; Fitting The Floor Tool - Numatic HTB 1840 Notice Originale

Machine Set-up Guide
!
Fitting the Brush / Pad / Turn on water
400mm Brush / 360mm Pad.
Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
Slide the brush / pad under the brush deck.
Fit the brush / pad onto the Nulock drive chuck, twist to lock the brush / pad in place.
Safety gloves are recommended for the changing of used brushes.
Turn on the clean water tap.

Fitting the Floor Tool

The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature if the
floor tool gets snagged, whilst in transit.
NOTE: It is easier to fit the floor tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
1
Swing the floor-tool carrier to the side
of the machine. (Fig.1).
Secure to the carrier using the two
knobs fitted to the floor-tool carrier
(Fig.2) - (Fig.3).
Do not over tighten the retaining
knobs.
Ensure inspection cap is in place on
the fluid pipe. (Fig.4) - (Fig.5)
For fitting the floor tool blades
(See Page 10).
9
www.numatic.co.uk
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
2
4
3
5
!