Regular Maintenance; Emptying Top/Bottom Tanks - Numatic HTB 1840 Notice Originale

Regular Maintenance

!
A
Separator
Remove the two hoses to disconnect the separator from the
machine (Fig.1 & 2).
Remove fixing band holding separator in place (Fig.3).
Lift off the separator. The separator has a sealing-rubber which
should be examined at every clean-down (Fig.4).
Rinse using clean water.
Remove the two filters clipped into the separator and flush with clean water (Fig.A & B).
Replace by fitting the rear of the filter first then clipping the front to lock in place.
ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED
PRIOR TO ANY MAINTENANCE OPERATION
B
A
4
Emptying Top Tank
After use, empty waste-water tank using
emptying hose and flush-out with clean
water. (fig.A).
Emptying Bottom Tank
The clean-water tank can be drained via
the yellow cap fitted to the left hand side
of the machine. There is a sealing bung
beneath the yellow cap (ensure the sealing
bung is clean) The cap should only be done
up by hand. (fig.B).
1
2
B
T 01460 68600
!
3
17