Waring Commercial WW250X2 Mode D'emploi page 5

INSTRUCTIONS FOR USE
1. Before using your Waring
time, remove any dust from shipping by wiping the plates with a
damp cloth. Remove all protective paper and wrapping.
2. Plug cord into 120V AC, 20 Amp (NEMA 5-20) wall outlet (for
WW250X2) or 208V AC wall outlet (for WW250BX2). Each waffle
unit works independently. You can use one at a time or both at
the same time. Switch the toggle switch or switches to the ON
position. The red light(s) will go on to signal power. The waffle
unit(s) will now begin the preheating process. This should take
about 3-4 minutes. Each unit will sound 6 beeps and the green
indicator light(s) will go on to signal the unit is ready for baking.
Season the waffle grids by spraying with cooking spray or
brushing with a flavorless oil.
For initial use, it is important that the waffle maker is
preheated before seasoning with cooking spray or oil.
NOTE: The first time you use your waffle maker, it may have a
slight odor and may smoke a bit. This is normal,
and common to heating appliances.
3. Preheat your Waring
or preferred setting (green indicator lights will be illuminated
when preheated).
For best results, do not open waffle maker during cooking
process. Doing so will interfere with the timing mechanism.
4. Fill measuring cup to Belgian Waffle fill line (top line on batter
cup) marking or to top of measuring cup, depending on the
recipe. (For loose batters, fill to the fill line; for thicker batters,
fill to the top) and pour batter evenly into the center of the waffle
grids. Use a heat-proof spatula to spread the batter evenly over
the grids. Close the lid and rotate the unit 180° to the right.
5. When the waffle is completely baked, the waffle maker will
sound 3 beeps. Baking time is determined by browning level.
Choose a setting on the browning control dial. For golden
brown waffles, we recommend using setting #4.
6. Once the waffle(s) are ready and the waffle maker has beeped
3 times, rotate the waffle maker 180° to the left, open the lid and
remove waffle(s) by gently loosening the edges with a heat-
Commercial Waffle Maker for the first
®
Commercial Waffle Maker on setting #4
®
5