Metal Grease Filters; Cleaning The Filters - AEG DD8694-M Mode D'emploi Et Installation

11
MAINTENANCE
MAINTENANCE
cLeANINg THe cOMFORT PANeLS
• Pull the Comfort Panel to open it.
• Disconnect the panel from the hood canopy by
sliding the fixing pin lever.
• The comfort panel must never be washed in a
dishwasher.
• Clean the outside by using a damp cloth and
neutral liquid detergent.
• Clean the inside as well by using a damp cloth
and neutral detergent; do not use wet cloths or
sponges, or jets of water; do not use abrasive
substances.
• When the above operation has been completed,
hook the panel back to the hood canopy and close
it by turning the knob in the opposite direction.

MeTAL gReASe FILTeRS

Filters can be washed in the dish machine. They need
to be washed when F-sign appears on the display or
in any case every 2 months, or even more frequently
in case of particularly intensive use of the hood.
Alarm reset
• Switch off the hood and the lights.
• Press the D-key till the display is unlit.

cleaning the filters

• Pull the comfort panels to open them.
• Remove the filters one by one pushing them
towards the back side of the hood unit and si-
multaneously pulling downwards.
• Any kind of bending of the filters has to be avoided
when washing them. Before fitting them again
into the hood make sure that they are completely
dry. (The colour of the filter surface may change
through-out the time but this has no influence
to the filter efficiency).
• When fitting the filters into the hood pay atten-
tion that they are mounted in correct position the
handle facing outwards.
• Close the comfort panel.