VALBERG WF 812 B W701T Consignes D'utilisation page 42

C
Useful information
Fault
Your machine vibrates.
Excessive foam is formed
in the detergent drawer.
Unsatisfactory washing
result.
Unsatisfactory washing
result.
As soon as the machine is
loaded with water, water
discharges.
No water appears in the
drum during washing.
Laundry has detergent
residue.
Possible cause
The feet have not been
adjusted.
Transit bolts fitted for
transportation have not been
removed.
Small load in the drum.
Your machine is overloaded
with laundry or laundry is
unevenly spread.
Your machine rests on a hard
surface.
Excessive amount of detergent
used.
Wrong detergent used.
Your washing is too dirty for
the programme selected.
Amount of detergent used
insufficient.
There is too much laundry in
your machine.
Hard water.
Your laundry is too tightly
packed together in the drum.
The end of water drain hose is
too low for the machine.
No fault. Water is in the
unseen part of the drum.
Non-dissolving particles of
some detergents may appear
on your laundry as white spots.
39 EN
Troubleshooting
Adjust the feet. (**)
Remove the transit bolts from
the machine. (**)
This will not prevent operation
of your machine.
Do not overload the drum.
Spread laundry evenly in the
drum.
Do not set up your Washing
Machine on a hard surface.
Press the Start/Pause button.
To stop the foam, dilute one
tablespoon of softener into 1/2
litre of water and pour into the
detergent drawer. Press the
Start/Pause button after 5-10
mins.
Only use detergents produced
for automatic Washing
Machines.
Use the information in
the programme tables to
select the most appropriate
programme.
Use the amount of detergent
as instructed on the packaging.
Check that the maximum
capacity for the selected
programme has not been
exceeded.
Increase the amount of
detergent following the
manufacturer's instructions.
Check that your laundry is
spread out.
Check that the drain hose is at
a suitable height. (**) .
/
Perform an extra rinse, or
clean your laundry with a
brush after it dries.